Step 1 Cast and clean the greenware.
Step 2 Roll dinnerware safe clear glaze on the inside.
Step 3 Fire to
cone 04.
Step 4 Paint the outside of the entire piece Raven Black acrylic
stain. (I use a Golden Taklon Glaze/Wash Brush on smooth surfaces for a
more even finish.)
Step 5 Spray seal by applying 2 light applications of
CTM-1 Flat Matte.
Step 6 Allow to dry thoroughly. (If not dry, the rub-on will lift
the paint.)
Step 7 Cut around rub-on leaving 1/'8" to edge and then remove
backing sheet.
Step 8 Position the rub-on onto the surface.
Step 9 Rub the design with the enclosed stick.
Step 10 Gently pull off the plastic sheet to reveal the design.
This process requires patience. If you start lifting it and the design
is coming up with the plastic, rub that area again until that part of
the design remains on the cup. Slowly work from one edge until the
entire design is on the cup free of the plastic.
Step 11 Spray seal again by applying 2 light applications
of
CTM-1 Flat Matte. |
